Materials

These are some of our instruments and methods for materials and coatings.

ASTM Method Description Instrument
D2625 Endurance (Wear) Life and Load-Carrying Capacity of Solid Film Lubricants (Falex Pin and Vee Method)
D2714 Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine
D2782 Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method)
D2981 Wear Life of Solid Film Lubricants in Oscillating Motion
D3233 Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods)
D3702 Wear Rate and Coefficient of Friction of Materials in Self-Lubricated Rubbing Contact Using a Thrust Washer Testing Machine
D5183 Determination of the Coefficient of Friction of Lubricants Using the Four-Ball Wear Test Machine
D5620 Evaluating Thin Film Fluid Lubricants in a Drain and Dry Mode Using a Pin and Vee Block Test Machine Falex Pin and Vee
B611 Abrasive Wear Resistance of Cemented Carbides
G65 Measuring Abrasion Using the Dry Sand/Rubber Wheel Apparatus Falex Dry Sand/
Rubber Wheel
G75 Determination of Slurry Abrasivity (Miller Number) and Slurry Abrasion Response of Materials (SAR Number) Falex Miller Machine
G76 Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets
G77 Ranking Resistance of Materials to Sliding Wear Using Block-on-Ring
Wear Test
G83 Wear Testing with a Crossed-Cylinder Apparatus
G99 Wear Testing with a Pin-on-Disk Apparatus
G105 Conducting Wet Sand/Rubber Wheel Abrasion Tests
G132 Pin Abrasion Testing
G137 Ranking Resistance of Plastic Materials to Sliding Wear Using a Block-On-Ring Configuration
G176 Ranking Resistance of Plastics to Sliding Wear Using Block-on-Ring Wear Test—Cumulative Wear Method




Web design by Composure Graphics, Nashotah, WIwww.ComposureGraphics.com